Premium Hot Selling Brand Frotek Automatic Watering System Kit Acid Resistant Auto Stop Refill Valve For Warehouse Forklift Tractor Industrial Lead Acid Battery Maintenance

Full Set Components

l Automatic Watering Plug

l End Plug

l Floater

l T-piece & L-piece

l Flow Indicator(with filter)

l 6mm, 8mm ,10mm watering pipe

l Male & Female couplings (KV10 and KV6, etc.)

l Water Tank

24V / 48V / 80V full accessory configuration

Automatic Watering System of Forklift Storage Battery-48V battery group

Key Product Advantages

1.Labor & Cost Saving 

  No tedious manual water filling, drastically cut maintenance labor cost & working time
  One-time full set installation, long-term reuse, reduce battery replacement expenditure

2.Precise Automatic Liquid Level Control

  Built-in sensitive floater valve, auto shut-off when electrolyte reaches standard height

  Every single cell keeps uniform water level, avoid overfilling / underfilling caused by manual operation

3.Excellent Sealing & Anti-Leak Design

  Fully sealed pipeline matching T/L-piece, zero leakage during watering

  Terraced step structure on watering plug, cool & recycle electrolyte gas, prevent acid liquid overflow & corrosion
  Premium anti-rust, anti-corrosion plastic raw material, stable tightness under long-term industrial use

4.Safe & Easy Operation

  Simple single-point water inlet design, support gravity tank / pump cart / tap water with ionizer 3 supply modes
  Equipped with filter-type flow indicator, real-time observe water flow, block impurities to avoid valve failure
  Operate after battery fully charged, effectively cool battery, avoid leakage risk during charging

5.Extend Battery Service Life

  Balance electrolyte level of all cells, eliminate inconsistent battery aging
  Prevent acid erosion, reduce internal plate damage, prolong whole battery pack service life

6.Eco-Friendly & Low Maintenance

  Water-saving design, no waste of distilled water; recyclable all plastic accessories
  Easy daily cleaning: only rinse plug & pipe with tap water, no extra detergent needed

Key Points to Note

• Working Pressure Requirement

Water supply pressure must keep 0.2–2.5 bar, water tank height ≥2m above battery surface; too high pressure leads to early shut-off, too low pressure causes incomplete water filling.

• Best Watering Time

Only add water after battery full charging, strictly forbid watering before charging. High temperature after charging helps battery heat dissipation, avoid electrolyte overflow during charging cycle.

• Daily Maintenance Tips

1. Keep water tank & pipeline clean, no dirt or impurities; use filter flow indicator to block foreign matter.

2. Prevent system from freezing in low temperature environment, frozen pipe will cause valve failure.

3. After watering finished, close water source immediately, max residual drip ≤2ml/min.

4. Regularly check plug shut-off performance, replace watering plug if sealing failure occurs. 

FAQ

Q1: Can this system fit all forklift batteries?

A1: We provide multiple floaters for separator height 49–75mm, customized pipe length & plug quantity for 24V/36V/48V/80V battery groups, compatible with most mainstream forklift battery brands.

Q2: How long is the service life of the whole set?

A2: High-quality anti-acid plastic accessories, service life longer than forklift battery, only replace individual watering plug when damaged.

Q3: Is installation hard? Can you provide installation drawings?

A3: Easy DIY installation, we supply detailed installation diagram & operation video for all clients.

Q4: What if the plug cannot shut off water automatically?

A4: Check if there’s impurity blocking floater, clean pipeline & filter; if floater mismatches battery height, replace matched floater.